Aftercare Instructions

To Keep Your Film Looking Great, Follow A Few Simple Guidelines:

• Wait 48 hours after installation to wash your car.
• Remove insect or other stains as soon as possible with XPEL Film Cleaner.
• Stubborn stains can be removed with 99% isopropyl alcohol. Take care to keep these chemicals off the vehicle’s paint.
• Seal with XPEL Ceramic Boost at least once every 6 months to preserve high gloss.
• Light scratches in the film will self-heal in 20-30 minutes at room temperature. In colder conditions, or to accelerate the process, pour warm water (120°F) over the affected area.
• Avoid using a pressure washer or high-pressure water source near the edges of the film, it can cause the film to lift and/or become damaged.
• Detailing Clay can be used to remove contaminants that are on the film.

XPEL PRIME Automotive Window Films Were Designed To Keep Their Flawless Appearance And Clarity For Many Years. Follow These Tips To Properly Care For Your Windows And Keep Them Looking Their Best:

• Keep in mind that your window tint may have a hazy appearance or moisture bubbles for up to ten days after installation. These conditions will disappear once the moisture used to apply your tint dries up completely.
• Wait approximately 1-5 days after installation before rolling down or cleaning your windows based on the climate in which it was installed.
• Use a microfiber towel slightly dampened with water to clean your windows. If necessary, mild, non-ammonia glass cleaners may also be used.
• Avoid the use of abrasive materials such as scouring pads, to clean your tinted windows.

• For exterior cleaning, we recommend using XPEL Rinse Free Car Wash on a weekly basis, to avoid excessive contamination buildup. Avoid washing in direct sunlight to minimize streaking and water spotting.

• Wash from the roof downwards, leaving the dirtiest sections last, avoiding possible cross-contamination. You can follow up with XPEL Detail Spray and XPEL Ceramic Boost for added gloss.
• Always dry the exterior surfaces completely using a clean, soft, lint free microfiber towel or air blower. Never allow water to evaporate on its own. Tap water can contain minerals which leave deposits on your coating, creating unwanted water spots.
• For best results use XPEL Microfiber Towels, which have been designed to absorb water. Always avoid aggressive wiping.
• For exterior surfaces, follow washing and drying steps above. Follow up with XPEL Detail Spray for any left- over fingerprints or smudges on your paint protection film or surface. You can apply the XPEL Ceramic Boost (as needed) for added shine and slickness.
• Avoid applying XPEL Detail Spray or XPEL Ceramic Boost in direct sunlight, to minimize streaking and water spotting
• Never use aggressive products to polish the coating or to removing surface contamination.
• Visit your authorized XPEL FUSION PLUS installer for any questions you have on your coated surfaces.
• To uphold the FUSION PLUS warranty, you must visit your FUSION PLUS certified installer (who applied your original coating), annually, during the duration of warranty. If you have had a change of address, please email warranty@xpel.com with any questions.